Table of Contents
Advertisement
Before you begin printing, at any time, but especially when you are new to
the process. it is a good idea to run a test or sample print. To do this, take the
printer Off Line. Then press and hold [TEST] until the display reads Status
Sheet. The printer will provide a status sheet showing.
l
its configuration
l
the quality of its text printing, and
-
l
a summary of its settings -
initial and power-up preset.
-.
4.3 CONNECTING
THE PRINTER TO THE
COMPUTER
c-
-
The Star LaserPrinter
4111 comes equipped
with a standard Centronics
parallel interface. and an RS-232 serial interface. They can be connected
simultaneously,
though only one can be active at any one time.
The printer comes from the factory pre-set with the Centronics
parallel
interface active. You can confirm this by looking at the Interface Group
portion of the sample print.
r-
Star Laser-Printer 4111
Status and Setup Report
Configuration
Firmware
rev.:
1.00
Page count:
1210
RAM size:
On-board
1024K
bytes
Expansion
OK
bytes
Available
628K bytes
/---
1
-
-
This means that the Centronics parallel interface is active. If the serial port
were active, that line would state serial.
48
Advertisement
Table of Contents
