Table of Contents
Advertisement
__
.._-
--
If you are going to use a Centronics interface, you don't need to make any
changes. If you want to use an RS-232 interface,
you must perform a
programming
sequence. Programming
will involve pressing various panel
keys and following the information
provided on the display screen. The
control panel indicates the selected function with the@ symbol following the
function displayed.
4.3.1 Selecting the Serial Interface
l
Take the printer Off Line by pressing the [ON LINE] button until the
button's light is ofs
l
Then press [PROGRAM].
l
Press [<I until the display screen reads
INTERFACE
l
Press [v]. Now the screen will read
PARALLEL@
l
Now press [<I. The screen will change to
SERIAL
l
With the display reading SERIAL, this time press [v]. The screen will
show
BAUDRATE
; Pressing [v] now displays
9600baud
l
Press [<I to display a series of options, from 300 to 38400. Keep
pressing until the one you want appears on the screen.
l
Pressing [v] now displays
9600baudQ
49
Advertisement
Table of Contents
