ZOLL M Series Manual page 13

WARNING Do not start NIBP measurements unless you are sure that the cuff inflation and alarm settings are
appropriate for the patient. Incorrect settings can result in patient injury or inaccurate measurements.
Table 3 Accessing NIBP Features
Task
Taking a single measurement.
Taking STAT measurements.
Taking automatic measurements.
Aborting measurement in progress.
Changing NIBP settings.
Displaying the NIBP Menu
Unless it is an emergency situation where quick reaction is essential, you should always check that the
cuff inflation and alarm settings are set properly before taking a measurement. You can access all
NIBP features through the NIBP menu (see Figure 1 on page 3). You can display the NIBP menu
without leaving Monitor, Defib or Pacer mode. AEDs must be in manual override mode to display the
NIBP menu.
To display the NIBP menu:
Displaying the
NIBP Menu
1. Press the Param softkey. If the Param softkey label is not displayed, press the Return softkey
until "Param" displays.
The M Series unit displays the Parameter menu (see the following figure):
Figure 3 Parameter Menu
Select
2. Press the Select softkey until "NIBP" highlights.
3. Press the Enter softkey.
The M Series unit displays the NIBP menu:
Figure 4 NIBP Menu
NIBP
Stat
On M Series CCT units, the following NIBP menu appears:
Figure 5 NIBP Menu (CCT only)
NIBP
Stat
SpO2
EtCO2
NIBP
Enter
NIBP Cuff
Auto Inflation
NIBP NIBP
Auto PT. Type Settings
ZOLL M Series Operator's Guide - Option Insert
Preparing to Take Measurements
Action
Press the NIBP button.
Press and hold the NIBP button for two seconds.
See "Displaying the NIBP Menu" on page 7.
Press the NIBP button.
See "Displaying the NIBP Menu" on page 7.
Return
Auto
Interval Return
Return
7