Table of Contents
Advertisement
Rev. 1.1
6 Operation
6.1 General Information
This device may only be operated if the safety-related equipment is permanently effective and not suspend-
ed during operation or altered in its intended effectiveness.
6.2 Operation Instructions / Operating Conditions
CAUTION
Never point the jet at people. The wearing of eye protection is strongly recommended.
The spraying process can create noise depending on the air and fluid pressures used.
Ear protection should be worn, if required.
WARNING
Danger caused by flammable, harmful fluid. Always follow the safety instructions on the
container or the safety data sheet for the fluid.
As a norm the Airless-Spray Valve SMS-13 operates with a control air pressure of 6 bar.
IMPORTANT
In case high material pressures are required, make sure that the accident prevention
regulations of the trade associations will be strictly followed!
The application can be controlled as intermitting or continuous. Depending on the individual use, the control
pressure has to be adjusted to the set switching frequency on the one hand and to the higher or lower
material pressures on the other.
Important
The maximum material pressure will be 150 bar. It must in no case be exceeded.
Please contact the manufacturer, if you have to work with higher pressures.
For longer standstills, the material can remain in the valve, if it remains under pressure (no contact to outside
air).
Assembly Instructions - Spray Valve SMS-13
Walther Systemtechnik GmbH – D 76726 Germersheim
Telefon: +49 (0)7274-7022-0 Telefax: +49 (0)7274-7022-91
http://www.walther-2000.de – info@walther-2000.de
Page 8 of 26
Advertisement
Table of Contents
