X200-X202 Drive-Cliq Interfaces; 24 V Busbar; Active Line Module Dc Link Busbar - Siemens SINUMERIK 840D sl Manual

5.3.2.6

X200-X202 DRIVE-CLiQ interfaces

Table 5-5 DRIVE-CLiQ interface X200-X202
PIN
1
2
3
4
5
6
7
8
A
B
Blanking plate for DRIVE-CLiQ interface: Molex, order number: 85999-3255
5.3.2.7

24 V busbar

Busbar
+
M
5.3.2.8

Active Line Module DC Link Busbar

Busbar
DCP
DCN
The Active Line Module is controlled using the -X21 terminal block, terminal 3 and 4 (EP),
and using DRIVE-CLiQ at the -X200/202/203 terminal block. The detailed function
description for the individual signals and control/status words is contained in the
SINAMICS S Parameter Manual.
Once the Active Line Module has been switched on, the DC link has been precharged and
the boost converter has attained the setpoint of the DC link voltage, the unit uses the r0863.0
parameter to signal the "infeed ready" status. The signal must then be connected by
parameter for enabling the Motor Modules. This ensures that the Motor Modules can be
started only when the DC link is operating correctly. The Motor Modules will be disabled
immediately in case of faults, etc.
Guide for the SINUMERIK 840D sl machine configuring
Manual, 07/2006 Edition, 6FC5397-6CP10-0BA0
Signal name
TXP
TXN
RXP
Reserved, do not use
Reserved, do not use
RXN
Reserved, do not use
Reserved, do not use
+ (24 V)
M (0 V)
Designation
24 VDC power supply busbar, plus
pole
24 VDC power supply busbar, ground
pole
Designation
DC link plus pole
DC link minus pole
Connection of the Components
5.3 Line Modules Interfaces Description
Technical specifications
Transmit data +
Transmit data -
Receive data +
Receive data -
24 V power supply
Electronics ground
Remarks
Two connection straps on the distribution busbar
can be used to pass the voltage potential to
neighboring components.
Remarks
Two connection straps on the distribution busbar can be
used to pass the voltage potential to neighboring
components.
5-21