Table of Contents
Advertisement
Connection
6.2 Electrical connection
6.2.6
Electrical connection data
Table 6- 4
1PH8 motors, shaft height 132
Terminal
Cable entry
box type
(power)
gk833
1 x M40 x 1.5
gk843
1 x M50 x 1.5
gk846
1 x M50 x 1.5
Nole with ∅ 22 mm, 90° to signal connection
1)
Depending on design of metric cable gland
2)
Current-carrying capacity based on EN 60204-1 and IEC 60364-5-52, routing type C
3)
6.2.7
Motors with DRIVE-CLiQ interface
Motors designed for SINAMICS drive systems are equipped with an internal Sensor Module,
which contains an encoder and temperature evaluation system as well as an electronic
rating plate. The Sensor Module is mounted instead of the signal connector and is equipped
with a 10-pin RJ45plus socket. This is known as a DRIVE-CLiQ interface. The pin
assignment is independent of the motor-internal encoder. The Sensor Module can be rotated
through approx. 180°. The typical torsional torque is between 4 and 8 Nm. The Sensor
Module must only be rotated by hand. The use of pipe wrenches, hammers etc. is not
permitted.
NOTICE
The Sensor Module is in direct contact with electrostatically-sensitive components. It is not
permissible to touch the connections with either hands or tools that could be
electrostatically charged.
Figure 6-7
44
Cable entry
Max. external
(external signals)
cable diameter
1 x ∅ 22 mm
32 mm
1)
1 x ∅ 22 mm
38 mm
1)
1 x ∅ 22 mm
38 mm
1)
Motor with DRIVE-CLiQ interface (example)
Number of main
Max. cross-
terminals
section per
2)
terminal
Phases: 3 x M6
1 x 35 mm
Grounding 2 x M6
Phases: 3 x M6
1 x 50 mm
Grounding 2 x M6
Phases: 6 x M6
1 x 25 mm
Grounding 2 x M6
Synchronous/induction motors 1PH813
Operating Instructions, 04/2009, 610.48000.22
Max.
current per
terminal
3)
104 A
2
125 A
2
84 A
2
Advertisement
Table of Contents
