GRAUPNER GR-18 Manual page 17

SCREEN DISPLAY
MIXER
FROM CHANNEL
TO CHANNEL
TRIM
TRAVEL -
TRAVEL +
Mixer
up to four mixers can be programmed simultaneously. You can switch between Mixer 1, Mixer 2, ... and mixer 4 in the
"Mixer" line. The following settings only afect the mixer selected in this line.
From channel
the signal present at the signal source (or source channel) is mixed in to the target channel (TO CHANNEL) to an extent
which can be set by the user. The method of setting up the values is analogous to the "Free mixers" menu in HoTT
transmitters.
To channel
part of the source channel signal (FROM CHANNEL) is mixed into the target channel (TO CHANNEL). The mixer ratio is
determined by the percentage values entered in the "TRAVEL-" and "TRAVEL+" lines. Select "0" if you do not require
the mixer.
modellmarkt24.ch; modellmarkt24.ch;
52
KEY
Mixer select
Signal source / source channel
Target channel
Trim position in %
Travel limit at % Servo travel
Travel limit at % Servo travel
SETTINGS
1, 2,....., 4
0,1,2,...6
0,1,2,...6
-15 - + 15%
-150 bis +150%
-150 bis +150%
www.modellmarkt2 www.modellmarkt2