CURRENT TEMPERATURE CORRECTION
1
It is used for correcting the temperature measured by the thermostat. We
recommend that you do the setting after 12-hour operation when the inter-
nal sensor temperature settles. Measure the room temperature with a ther-
mometer; if it differs from the thermostat temperature, set the correction
within the range of -5°C to +5°C.
Set the pertinent value with the
MENU
button.
"OPEN WINDOW" FUNCTION
2
If the room temperature drops suddenly (by 1-2 °C in 2 minutes), BPT710
sends out a signal to switch off the heaters to save energy in this way.
To enable this function, set the „ A" option with the
confi rm it with the
confi rm it with the
If the function is active, the UtLUM message appears on the display.
The mode is terminated if the temperature rises, or after 30 minutes.
ACTIVATION OF RECEIVERS
3
This function is used for activation of up to 9 receivers.
The display shows tESt 1-, where 1 indicates the sequence of the activated
receiver. Press the „FUNCTION BUTTON" on the receiver (for about
1.5 s), thus you introduce the receiver into the learning state (see the
pertinent receiver manual – BPT001, BPT002 or BPT003). The LED1 and
LED2 diodes are fl ashing alternately on the receiver. Press the
on the BPT710 transmitter; tESt On 1A/tESt OFF 1A appears on the LCD
and the code is send to the receiver. Code acceptance is confi rmed on the
receiver by simultaneously fl ashing diodes, thus the activation is comple-
ted. To activate the next receiver, proceed in a similar way.
Choose another receiver with the
LCD. Introduce the next receiver into the learning state by pressing the
„FUNCTION BUTTON" (for about 1.5 s) and start the activation with the
button on BPT710. In this way, you can gradually activate up to
9 receivers.
If you do not want to activate another receiver, simultaneously press the
MENU
and
/
7
MENU
button. To disable, choose the „ -" symbol and
MENU
button.
buttons to return to the basic mode.
/
button; confi rm it with the
/
button, tESt 2- appears on the
button and
button
Need help?
Do you have a question about the BPT710 and is the answer not in the manual?