Brocade Communications Systems 7810 Hardware Installation Manual page 38

Installing the Universal Two-Post Rack Kit (XBR-R000294)
5. Tighten all the 10-32 x 5/8-in. screws to a torque of 25 in-lb. (29 cm-kg).
FIGURE 18 Attaching the Rear Brackets to the Rack
1. Retainer Nuts, 10-32
2. Rear Brackets
Attaching the Rear Brackets to the Device
Complete the following steps to attach the rear brackets to the device.
1. Align the right rear bracket to the right rear of the device and use four 8-32 x 5/16-in. panhead screws to attach the bracket to
the device, as shown in
2. Align the left rear bracket to the left rear of the device and use four 8-32 x 5/16-in. panhead screws to attach the bracket to the
device. Again, use the upper and lower slots in the bracket.
38
Figure 19. Be sure to insert the screws through the upper and lower slots in the bracket.
3. Screws, 10-32 x 5/8-in., Panhead Phillips
Brocade 7810 Extension Switch Hardware Installation Guide
7810-IG101