Brocade Communications Systems 7810 Hardware Installation Manual page 36

Installing the Universal Two-Post Rack Kit (XBR-R000294)
3. Attaching the Rear Brackets to the Rack
4. Attaching the Rear Brackets to the Device
Attaching the Front Brackets to the Device
Complete the following steps to attach the front brackets to the device.
1. Position the right front bracket with the flat side against the right side of the device, as shown in
2. Insert four 8-32 x 5/16-in. flathead screws through the vertically aligned holes in the bracket and then into the holes on the
side of the device. Use the upper and lower screw holes, leaving the center holes empty.
3. Repeat Steps 1 and 2 to attach the left front bracket to the left side of the device.
4. Tighten all the 8-32 x 5/16-in. screws to a torque of 15 in-lb (17 cm-kg).
FIGURE 16 Attaching the Front Brackets
1. The Brocade Device
2. Front Brackets, Right and Left
Attaching the Front Brackets to the Rack
Complete the following steps to install the device in the rack.
1. Position the device in the rack, as shown in
secured to the rack.
2. Attach the right front bracket to the right rack upright using two 10-32 x 5/8-in. panhead screws and two retainer nuts. Use the
upper and lower holes in the bracket.
36
on page 37
on page 38
(Figure 17), providing temporary support under the device until the rack kit is fully
Figure
3. Screws, 8-32 x 5/16-in., Flathead Phillips
Brocade 7810 Extension Switch Hardware Installation Guide
16.
7810-IG101