Brocade Communications Systems 7810 Hardware Installation Manual page 37

3. Attach the left front bracket to the left rack upright using two 10-32 x 5/8-in. panhead screws and two retainer nuts.
Use the upper and lower holes in the bracket.
4. Tighten all the 10-32 x 5/8-in. screws to a torque of 25 in-lb. (29 cm-kg).
FIGURE 17 Attaching the Front Brackets to the Rack
1. Screws, 10-32 x 5/8-in., Panhead Phillips
Attaching the Rear Brackets to the Rack
Complete the following steps to attach the rear brackets to the rack.
1. Select the proper length bracket for your post width. If your posts are 3 to 5 inches wide, use the brackets marked 3-5 INCH. If
your posts are 5 to 6 inches wide, use the brackets marked 5-6 INCH.
2. Position the right rear bracket in the right rear of the device, as shown in
3. Attach the bracket to the right rack upright using two 10-32 x 5/8-in. panhead screws and two retainer nuts. Use the upper and
lower holes in the bracket.
4. Repeat Steps 2 and 3 to attach the left rear bracket to the left rack upright.
Brocade 7810 Extension Switch Hardware Installation Guide
7810-IG101
Installing the Universal Two-Post Rack Kit (XBR-R000294)
2. Retainer Nuts, 10-32
Figure 18.
37