Brocade Communications Systems 7810 Hardware Installation Manual page 25

5. Tighten all 8-32 x 5/16-in. screws to a torque of 15 in-lb (17 cm-kg).
FIGURE 5 Attaching the Bracket Extensions to the Device
1. Bracket Extension
Installing the Device in the Rack
Complete the following steps to install the device in the rack.
1. Position the device in the rack, as shown in
rack.
2. Attach the right front bracket to the right front rack post using two 10-32 x 5/8-in. panhead screws and two retainer nuts. Use
the upper and lower holes in the bracket.
Brocade 7810 Extension Switch Hardware Installation Guide
7810-IG101
Figure 6, providing temporary support under the device the rail kit is secured to the
Installing the Universal Four-Post Rack Kit (XBR-R000296)
2. Screws, 8-32 x 5/16-in., Flathead Phillips
25