Secondary Swing Flap Motor - Daikin Stylish Series Service Manual

a Screw
b Swing flap motor gearcase assembly
3 Disconnect the swing flap motor harness from the swing flap
motor.
4 To install the swing flap motor gearcase assembly, see
procedures" on page 46.
To install the swing flap motor gearcase assembly
1 Connect the swing flap motor harness to the swing flap motor
connector.
2 Install the swing flap motor gearcase assembly on the indoor
unit and tighten using the 2 screws.
a Screw
b Swing flap motor gearcase assembly
3 Install the main swing flap in the indoor unit (by clicking it on).
Is the problem solved? Action
Yes No further actions required.
No Return to the troubleshooting of
the specific error and continue
with the next procedure.
2.16.2

Secondary swing flap motor

Checking procedures
To perform an electrical check of the swing flap motor
Prerequisite: Turn OFF the unit via the user interface.
Prerequisite: Turn OFF the respective circuit breaker.
Prerequisite: Remove the required plate work, see
work" on page 40.
1 Disconnect the motor connector from the indoor unit PCB.
(C)(F)TXA15~50A2V1B(W)(S)(T) + RXA42+50A2V1B +
RXA20~35A2V1B
Split Stylish R32
ESIE18-03 – 2018.09
a
2 Measure the resistance between the following pins of the motor
Pins
1-2
1-3
1-4
1-5
2-3
2-4
2-5
3-4
3-5
a b
4-5
Swing flap motor resistance
measurements are correct?
Yes
"Repair
No
Repair procedures
a
To remove the swing flap motor gearcase assembly
Prerequisite: Turn OFF the unit via the user interface.
Prerequisite: Turn OFF the respective circuit breaker.
Prerequisite: Remove the required plate work, see
work" on
1 Remove the main swing flap from the indoor unit (by clicking it
2 Remove the secondary swing flap from the indoor unit (by
3 Remove the right side fan guard from the indoor unit (by
a b
Swing raster
"2.13 Plate
connector. The measurements MUST be as shown in the table
below.
Measured resistance (Ω)
235
470
Action
Return to the troubleshooting of
the specific error and continue
with the next procedure.
Replace the swing flap motor,
see "Repair procedures" on
page 47.
INFORMATION
To replace the motor, the complete gearcase assembly
MUST be replaced.
page 40.
out).
clicking it out).
clicking it out).
b
c a
a Fan guard
b Rocker arm
c
2 Components
"2.13 Plate
Service manual
47