System Calibration; Setting Change; System Check; Bcm Initialization - Suzuki DF350A Setup Manual

SYSTEM CALIBRATION

Calibrate the SPC system and registers information of outboard
motor and remote control box in the BCM.
Perform this item when an outboard motor, remote control box,
and meters, are first installed on the boat. Also perform this item
when the BCM is replaced or the ECM or remote control box of
the outboard motor is replaced.

SETTING CHANGE

Sets, changes, or resets the remote control lever and tilt down.
Perform this item when the remote control box is disassembled
or when the tilt position is changed.

SYSTEM CHECK

Enables you to check the system configuration registered in the
master BCM.

BCM INITIALIZATION

Deletes the (master or sub) BCM information registered in the
BCM after system calibration and system configuration informa-
tion (*Number of engine, Number of station).
Exit
Exits the SDS program.
Close (Esc)
Closes the menu box.
NOTE:
• The ECM or BCM calibrated in one boat cannot be reused in
another boat.
To reuse the ECM or BCM, be sure to calibrate the system
after deleting the BCM information by using the BCM INITIAL-
IZATION menu.
• The BCM INITIALIZATION menu cannot be used to delete the
diagnostic information registered in the BCM.
• Use the BCM INITIALIZATION menu to delete information for
the connected BCM.
(To delete information for the master BCM, connect the diag-
nostic harness to the master BCM. To delete information for
the sub BCM, connect the diagnostic harness to the sub BCM.)
68