COMPONENT PARTS INSTALLATION OF KEYLESS START SYSTEM
After connecting the keyless start system component parts and
wiring harness, each component parts should be installed as fol-
lows.
Refer to "KEYLESS START SYSTEM COMPONENT/WIRE
CONNECTION DIAGRAM".
(1) Peel the back sheet of the cushion (1).
Stick the cushion (1) on the keyless parts holder (2) as
shown.
1; Cushion (P/no. 32851-93J00)
(2) Install the buzzer (3) onto its mounting post in the keyless
parts holder as shown.
(3) Place the ECM power relay and cushion (4) at the place in
keyless parts holder as shown.
(4) Assemble the keyless control unit (5) and cushion (6), then
install them into the keyless parts holder.
6; Cushion (P/no. 32980-38F00)
(5) Press the Black lead wire (7) and Yellow lead wire (8) con-
nectors at the front until lock as shown.
(6) Install the keyless parts holder at the appropriate place in
the cockpit with four screws.
1
3
5
8
7
2
4
6
97