TRANSOM DIMENSIONS
ESTABLISHING THE CENTER-LINE
To establish the center of the transom you may use the following
procedure:
(1) Measure across the transom from chine to chine and make
a mark on the transom face at 1/2 of this measurement.
(2) Measure across the transom from strake to strake and
make a second mark on the transom face at 1/2 of this
measurement.
(3) Align a straightedge with the marks on the transom face
and draw a line. This is the vertical center-line of the tran-
som for a single engine installation.
(4) Drill mounting holes as in a single engine installation.
8
158 (6.2)
147 (5.8)
Transom top surface
251 (9.9)
327 (12.9)
φ
5 – 14.7
φ
5 – 14.7
1/2
1/2
Chine
1/2
Strake
Unit: mm (in)
1/2