Table of Contents
Advertisement
13
21
20
16
17
Kicker and separator
1. Set the acceptor with the back of the unit facing you in the test position.
ITEM IDENTIFICATIONS
1 Kicker and Separator Screws
2 Washers
3 Kicker
4 Separator
5 Gate Lever Spring
6 Gate Pivot Pin
7 Mainplate Assembly
8 "C"
washer
9
Rail
1
o
Gate Assembly
12 Cradle Assembly
Upper Gate Pivot Spring
14 Undersize Lever Assembly
15 Magnet Gate Assembly
16 Magnet Gate Adjuster
17 Retaining Screws
18 Coverplate Assembly
19 Return Coverplate
20 Coverplate
21 Mounting Studs
22 Lower Gate Pivot Spring
23 Coin Release Lever
2. Loosen the kicker and separator screws (1) and move the kicker (3) and the separator (4)
as far to the right as they will go. Lightly tighten the screws.
3. Insert several test coins (both old and new) and note that some are returned by striking
the separator.
4. Loosen the separator screw and move the separator a slight amount to the left. Lightly
retighten the screw.
5. Insert the test coins again and, if some are still returned, repeat Step 4 until all the
coins are accepted.
6. Loosen the kicker screw and move the kicker as far to the left as it will go. Lightly retighten
the screw.
7. Insert the test coins and note that some are returned.
8. Loosen the kicker screw and move the kicker a slight amount to the right. Lightly retighten
the screw.
9. Insert the test coins again and, if some are still returned, repeat Step 8 until all the coins
are accepted.
10. Be sure that both screws are tight after tbe
adjustment~
have been made.
Magnet gate
1. Set the acceptor with the front of the unit facing you in the test position.
2. Turn the magnet gate adjusting screw (16) out or counterclockwise until none of the coins
will fit through.
3. With a coin resting in the acceptor entrance, turn the adjuster in or clockwise until the
coin barely passes through the magnet gate.
4. Test this adjustment using several other coins (both old and new) and, if any fail to pass
through the magnet gate, repeat Step 3 until all the coins are accepted.
5. Fix the magnet gate adjusting screw in this position with a drop of glue.
Additional Cleaning
1) Remove the transfer cradle (12) and the undersize lever (14).
2) Use a pipe cleaner or similar effective cleaning tool to clean the bushings and pivot pins.
3) Replace the transfer cradle and the undersize lever.
4) To be certain the coin mechanism is completely free of any residue. place the mechanism in
boiling water for several minutes. Carefully remove it and let it air-dry completely before
reinstalling in the door.
Figure 4-8 Adjustments on Coin Mechanism
Super Breakout 4-5
Advertisement
Table of Contents
