Chapter 2 Installation And Wiring; Compliance To European Union Directives; Emc Directive - Spectrum Controls Micro800 Series User Manual

Expansion i/o 32-point 24 v sink/source discrete output modules
Hide thumbs Also See for Micro800 Series:
Table of Contents

Advertisement

Chapter 2
Installation and Wiring
This chapter will cover:
Compliance to
European
Union Directives
This product is approved for installation within the European Union and EEA
regions. It has been designed and tested to meet the following directives.

2.1.1 EMC Directive

The 2085-OX32-SC modules are tested to meet Council Directive 2014/30/EU
Electromagnetic Compatibility (EMC) and the following standards, in whole or
in part, documented in a technical construction file:
WARNING
The module receives power through the bus interface from the +5 VDC (4.75 V
to 5.4 V)/±24 VDC (19.9 V to 26.4 V) system power supply, and a 24 VDC field
power supply. Both must be present for the module to operate.
Backplane current ratings: + 5 V rail is 70 mA maximum at 5 VDC; +24 V rail is
55 mA maximum at 24 VDC. Power rating for OB32 is 5.5 Watts maximum (at
full load); for OV32 is 4 Watts max. (at full load):
The maximum voltage to be provided by the user power supply is 30 VDC. The
minimum voltage provided by the user power supply is 10.5 VDC. 12/24 VDC

Compliance to European union directives

Power requirements
General considerations
Mounting
EN 61131-2 Programable Controllers Part 2: Equipment requirements and
tests
EN 61000-6-2 Electromagnetic compatibility (EMC) – Part 6-2: Generic
standards – Immunity standard for industrial environments
EN 61000-6-4 Electromagnetic compatibility (EMC)–Part 6-4: Generic
standards–Emission standard for industrial environments
The backplane power and each field power of the device shall only be
supplied by Isolated Secondary Limited Energy Low Voltage sources.
5 VDC
70 mA
24 VDC
55 mA
User's Manual Pub. 0300309-01 Rev. A

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Micro800 Series and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents