Table of Contents
Advertisement
User instructions
Last Channel Auto-Saving and Recall
If there is an interruption of AC power caused by pulling out the main plug of the RSD-7255 or brown-outs (power
interruptions), once AC power is reapplied the previous TV channel and last selected Audio mode, appears without having to
press the
key.
RF Tuning Function
You can watch Satellite channels and Terrestrial Broadcasting channels
using the RF Modulator.
1
Connecting to a TV which has direct RF channel "21" to "69" ("14" to
"83"-USA Channel) selection.
- Connect your TV RF input to the TV/VTR terminal of the RSD-7255.
Connect the terrestrial antenna cable to the ANT terminal of the
RSD-7255's RF Modulator.
- Tune the RF channel of your TV to channel "40". (The factory
default RF channel is "40").
2
Connecting to a TV which does not support direct RF selection.
- Connect your TV RF input to the TV/VTR terminal of the RSD-7255.
Connect the terrestrial antenna cable to the ANT terminal of the
RSD-7255's RF Modulator.
- Try to find the channel by using the Channel Search tuning function
of the TV.
3
If it is not possible to tune to the RF channel in the above-mentioned
cases, please try following steps for tuning RF channel:
- Connect your TV RF input to the TV/VTR terminal of the RSD-7255.
Connect the terrestrial antenna cable to the ANT terminal of the
RSD-7255's RF Modulator.
- Tune the TV to any RF channel "21" to "69" ("14" to "83"-USA
Channel) and press UHF key on the remote control. The front panel
display will show "No." followed by the RF channel number.
- Press
or
shows the TPSG (Test Pattern Signal Generator).
- Press EXIT or OK (LIST) key on the remote control to exit the RF
tuning mode.
- Go to the "Option" menu of the RSD-7255 and select the
appropriate "PAL Type" in the "UHF Standard" menu.
Press EXIT key to scape from the menu.
4
key of the RCU repeatedly until the TV screen
10
"RSD - 7255"
UHF TUNING MODE ...
PAL G
NO. 40
Test Pattern Signal
Advertisement
Table of Contents
