Weil-McLain SVF 1500 Manual page 82

SVF
™
Series 1
Commercial Condensing Gas-Fired Water Boiler — Boiler Manual
DIAGNOSTICS menu
Figure 75
Run Times
Displays cumulative time the burner has been active (can be increased by user)
Records the days of operation passed from the last time the Master boiler rotated the firing sequence.
Displays cumulative time that Input 1 has been closed (Or 0-10V ≥ 1 volt)
Displays cumulative time that Input 2 has been closed
Displays cumulative time that Input 3 has been closed
Records time this boiler was running on a network call for heat generated by the Master boiler
Displays total number of successful ignitions
Comm
Displays boiler control type and ID number
Shows if control is currently linked to a Master control
Shows number of boilers currently on network
Shows if this control is being requested to satisfy a network call
Shows whether the control is Network-P1, Network-P2, or NONE
Rate coming from the Master
Displays maximum allowable boiler temperature
Temperature differential from master boiler for network priorities
Temperature differential from master boiler for network priorities
Network Boilers
Shows current rate of boiler
Shows Boiler Out temperature of boiler
Shows priority being satisfied, updated based on active demand
Shows system type of call for heat, updated based on active demand
Shows the sequence position of that boiler in all the boilers available
Shows boiler number this data belongs to
Displays boiler number
Displays input's configuration and whether it is active. If input is active, it will be displayed in BOLD print
Software version of the microprocessor on the display circuit board
Software version of the main microprocessor on the control circuit board
Software version of the second microprocessor on the control circuit board
TO RESET
To reset all history counters to zero: Enter the DIAGNOSTICS menu. Then press and hold the left and right arrows
ALL HISTORY
located below the control display. Hold for 5 seconds. This will cause ALL history to be deleted. To maintain
COUNTERS TO
history, reset counters individually.
ZERO:
PAST ERRORS
Displays number of control faults
Displays cumulative ignition attempts. It is recommended that his be reset during yearly maintenance by holding down
the Left and Right arrows or by selecting this line and pressing the Enter button
Displays number of manual reset lockouts since last cleared
Displays number of auto reset lockouts since last cleared
Choose this to view the most recent error recorded
Displays the name of the fault that occurred
Displays the type of fault that occurred
82
(continued)
menu details (continued) (see Figure 63, page 72 for access information)
Comment
TM
SVF
Part number 550-100-250/0819