Weil-McLain SVF 1500 Manual page 10

SVF
™
Series 1
Commercial Condensing Gas-Fired Water Boiler — Boiler Manual
Prepare boiler
Cold weather handling
very cold location (below 32°F) before installation, handle with
astic components come to room temperature.
care until the pl
or cause bodily injury while lift ing and handling.
Boiler supply, return and gas pipes
handle the boiler by the water or gas pipes. Do not push on
or apply weight to the pipes. Severe damage can be done to
the boiler.
Leave the
nections and on the boiler vent and air adapters until ready
to att ach piping. Th is will protect the fi tt ings surfaces from
damage and prevent debris from falling into the vent or air
adapter.
Uncrating the boiler
Do not drop the boiler. Damage to boiler components can
result. Leave the boiler on the crate pallet until ready to place
in fi nal location. Follow all uncrating instructions.
Failure to comply could result in severe personal injury, death
or substantial property damage.
Figure 4
2500 boiler on pallet, with ramp in position
TM
SVF
down ramp. Potential bodily injury or boiler damage
could be caused while handling. Th e boiler should be
unloaded from the pallet onto a solid, level surface.
Apply pressure only to jacket
corners when moving
Brackets
(right & left sides
Pallet
10
(continued)
— If boiler has been stored in a
. Use caution not to drop the boiler
— Do not lift or
on the supply and return con-
. Use caution when rolling
1. See Figure 4 for the following.
2. Move the crate to a solid, level surface.
3. Th ere must be room (the length of the boiler plus 76" for
ramp) at the piping end to place the ramp and roll the boiler
down off the crate pallet.
4. Make sure the crate is sitt ing securely.
5. Remove the ramp from the crate and place the end of the
ramp into the notch in the pallet as shown in Figure 4 .
6. Follow the uncrating instruction label to secure the ramp
to the pallet.
7. Remove the sixteen (16) screws and lag bolts from the eight
(8) shipping brackets.
Th e boiler is heavy. Use caution when rolling
down ramp. Potential bodily injury or boiler
damage could be caused while handling. Th e
boiler should be unloaded from the pallet on to
a solid, level surface.
Moving/handling the boiler
manifolds.
Hex head bolts
3/8" wrench
Lag bolts
7/16" socket or
wrench
Notch
Ramp
Part number 550-100-250/0819