Chapter 4 - Operating Instructions - TriangleTube PRESTIGE Series User's Information Manual

CHAPTER 4 - OPERATING INSTRUCTIONS

FOR YOUR SAFETY, READ BEFORE LIGHTING
If you do not follow these instructions exactly, a fire or explosion may result,
causing substantial property damage, serious injury, or death.
A. This appliance does not have a pilot. It is equipped
with an ignition device which automatically lights
the burner. DO NOT try to light the burner by hand.
B. BEFORE OPERATING, smell all around the appliance
area for gas. Be sure to smell next to the floor be-
cause some gas is heavier than air and will settle on
the floor.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electric switch; do not
use any phone in your building
• Immediately call your gas supplier from a
neighbor's phone. Follow the gas suppli-
er's instructions.
• If you cannot reach your gas supplier, call
the fire department.
1. STOP! Read the safety information above. This ap-
pliance is equipped with an ignition device which
automatically lights the burner. DO NOT try to
light the burner by hand.
2. Set room thermostat(s) to lowest setting. Turn the
external manual gas valve handle clockwise
to "CLOSE" (valve handle must be perpendicular to
gas piping).
3. Turn the service switch on the appliance control
panel OFF.
4. Remove the front jacket panel on the unit.
5. Wait five (5) minutes to clear out any gas. If you
then smell gas in the jacket enclosure or around
the unit, STOP! Follow "B" in the safety information
above. If you don't smell gas, go to the next step.
6. Turn the external manual gas valve handle count-
er clockwise to "OPEN" gas supply (valve
handle shall be parallel to gas piping).
1. Set the room thermostat to lowest setting.
2. Turn the service switch on the appliance control
panel to "OFF"
WARNING
OPERATING INSTRUCTIONS
TO TURN OFF GAS TO APPLIANCE
C. Use only your hand to turn the external manual
gas valve. Never use tools. If the valve will not turn
by hand, don't try to repair it; call a qualified service
technician. Force or attempted repair may result in
a fire or explosion.
D. Do not use this appliance if any part has been
under water. Immediately call a qualified service
technician to inspect the appliance and to replace
any part of the control system and any gas control
which has been under water.
7. Turn the service switch on the appliance control
panel "ON".
8. Set room thermostat(s) to desired setting(s).
9. The appliance control panel display will show the
current operating status on the Status Line at the
bottom of the screen. "Standby" means there is
no call for heat (all thermostats are satisfied). "CH
Demand" indicates a space heating call has been
received. "DHW Demand" indicates a domestic hot
water call has been received. A flame icon will be
displayed when the unit is fired.
10. If the unit will not operate, follow the instructions
"To Turn Off Gas to Appliance" and call your service
technician or gas supplier.
11. Replace the front jacket panel. Make sure the panel
is seated firmly in place and all mounting screws
are tightened.
3. Turn the external manual gas valve handle clock-
wise to "CLOSE".
9