Fujitsu Stylistic Manual page 38

• You can remove the battery while the system
is in Suspend-to-RAM or Hibernate modes in
order to install a charged battery. To prevent
losing unsaved data, wait until system
operation has suspended before you remove
the battery. Note that after you remove the
battery, you have approximately five minutes
to replace it with a new battery or to plug in a
power supply before the bridge battery is
depleted.
• Your system may be configured to suspend
operation automatically after a period of
inactivity.
• Your system may be configured to enter
Hibernate mode automatically after a period
of time in Suspend-to-RAM mode.
• The system uses a small amount of battery
power when in Suspend-to-RAM mode.
Eventually, the battery will become fully
discharged.
If you will not be using the system for an
extended period of time, shut down the
system rather than using Suspend-to-
RAM mode.
• If the battery charge drops to a Low-Battery
Warning level while the system is running,
the system will beep periodically. If this
occurs, suspend system operation, shut
down the system, or attach an external
power source, such as the AC adapter, to
the Tablet PC.
30
• If the battery charge drops to a Critically Low
level while the system is running, the system
is forced into a pre-selected mode
(Suspend-to-RAM or Hibernate). If this
occurs, you must either install a charged
battery, or connect an appropriate external
power source such as the AC adapter before
you can resume system operation. (If the
battery charge drops to a Critically Low level
while the system is in Suspend-to-RAM
mode, the system stays in Suspend-to- RAM
mode until power is restored or totally
dissipated.)
• Suspending system operation interrupts
data communications; therefore, some
programs may block the system from
suspending to prevent an interruption.
• The suspend action of the Suspend/Resume
button may be disabled to prevent accidental
interruption. If this is the case, pressing the
Suspend/Resume button will not suspend
system operation as described here. (In this
case, suspend mode can only be achieved
using the system software). Contact your
local help desk or reseller if your system
configuration is not suitable.
• If your system is equipped with a PC Card
that allows you to connect to a wired or
wireless network, you may be logged off the
network after a period of inactivity while
system operation is suspended. Contact
your network administrator for details on log-
off parameters for your network.