Fujitsu Stylistic Manual page 60

7. Click [Refresh], then choose the correct
SSID from the [Available Networks]
window. Click [Configure] and proceed to
step 7. If the SSID of your access point
does not appear in the list, click [Add]. The
[Wireless Network Properties] window will
be displayed.
8. Select the Association tab if it is not
already selected.
9. Enter the information required for
connection to the wireless LAN.
a. Enter the network name (SSID). (i.e.,
Enter the name of the desired network
in less than 33 ASCII characters).
For ad hoc connection: Assign the same
network name to all the personal
computers to be connected.
For access point (infrastructure)
connection: Assign the appropriate
SSID. The SSID must be identical to the
SSID of the access point. Refer to the
access point manual, or contact your
network administrator.
b. For ad hoc connection, check the
following field. For access point
(infrastructure) connection, clear the
check mark for the following field: [This
is a computer-to-computer (ad hoc) net-
work; wireless access points are not
used.]
10. Enter the WEP key for encoding
communications data.
It is strongly recommended that you enter
the network key for encoding
communications data. If the network key
is not entered, since the network can be
accessed from all personal computers
containing the wireless LAN function,
there is the danger of your data being
stolen or damaged by other users.
52
a. Check the [Data encryption (WEP
enabled)] check box
For ad hoc connection: Clear the check
mark from the [Network Authentication
(Shared mode)] check box.
For access point (infrastructure)
connection: If the access point to be
accessed is configured for shared-key
authentication, check the [Network
Authentication (Shared mode)] check
box.
For open-system authentication, clear
the check mark. For access point setting,
refer to the manual of the access point.
b. Clear the check mark from the [The key
is provided for me automatically] check
box.
c. Enter data in [Network Key]. Depending
on the number of entered characters or
digits, whether the key is an ASCII
character code or a hexadecimal code
will be identified automatically.
• Use five or thirteen characters to enter
the key in the ASCII character code
format. The characters that can be used
as the "network key" are as follows: 0 -
9, A - Z, _ (underscore), or,
• Use 10 or 26 characters to enter the
key in the hexadecimal character code
format. The characters that can be used
as the "network key" in this case are as
follows: 0- 9, A - Z, a - f
For ad hoc connection: Assign the
same network key to all the personal
computers to be connected.
For access point (infrastructure)
connection: Assign the identical
network key that is programmed into
the access point. For this setting, refer
to the access point manual or contact
your network administrator.