Chassis Installation - Harmar Mobility Pinnacle Series Installation Manual

C. CHASSIS INSTALLATION
1. Remove chassis from box. Lift the chassis with
the manual override hole (on bottom) facing the
downhill side of the stairs and gently slide the
chassis onto the rail until it makes contact with the
plastic rack. DO NOT LET THE CHASSIS FREE FALL
DOWN THE RAIL. [Figure 7-1]
Be careful not to trap fingers
between the rail and the chassis.
WARNING
2. Use the installation switch (the black switch on
the top of the chassis) to move the chassis at least
24" down the rail, pushing gently on the chassis to
ensure the chassis does not pull any rack to the top.
[Figure 7-2]
3. Loosen, but do not remove, the four (4) seat-
leveling bolts two (2) on each side of the chassis)
and then align them vertically using a level. Firmly
tighten the two (2) bolts on the side of the chassis
facing the wall. [Figure 7-3]
Do not ride on the chassis or lift until
the install is complete.
WARNING
72618 P/N: 630-00100 Rev E
INSTALLATION PROCEDURES
Pinnacle SL300
Figure 7-1
Figure 7-2
Installation Switch
Figure 7-3
2 bolts on either side of chassis
SL300 • Pinnacle Stair Lift Installation Manual
7