Table of Contents
Advertisement
8. Position the seat directly aligned over the carriage
and place onto the seat swivel post. Depress
the swivel lever until the seat is fully engaged
with the swivel post. Check the swivel lever to
test the locking mechanism. THE SYSTEM WILL
NOT FUNCTION IF PROPER ENGAGEMENT IS NOT
ACHIEVED. [Figure 11-1]
9. Connect the seat cable to the 8-pin connector on
the chassis that is opposite the foot plate & closest
to the wall.
Insert 6-pin footrest cable into connector that is
adjacent to the 8-pin cable. [Figure 11-2]
F. PROCEDURE TO SWITCH ARMREST
CONTROL FROM RIGHT TO LEFT HAND
1. Turn the unit off
2. Remove the integrated paddle switch / palm rest
by removing screw underneath the arm [Figure 11-
3].
3. Disconnect the wires from the switch
[Figure 11-4] and then cut off the connectors and
remove seatbelt bolts in order to re-rout harness.
[Figure 11-5]
4. Remove upper half of both armrests.
5. Reroute the harness to the other armrest.
[Figure 11-6]
6. Re-terminate the wires and connect the switch.
7. Reassemble arms and reinstall seatbelt.
72618 P/N: 630-00100 Rev E
INSTALLATION PROCEDURES
Figure 11-3
Figure 11-5
Pinnacle SL300
Figure 11-1
Figure 11-2
SL300 • Pinnacle Stair Lift Installation Manual
Figure 11-4
Figure 11-6
11
Hide quick links:
Advertisement
Table of Contents
