Status Displays - NewMar SilverLeaf RV-C Control System Training Manual

Genset Button (Top Center) – Pressing this
button will manually start and stop the
generator. The button indicator is
highlighted when the generator is running.
This button works the same as the Dash and
other remote switches.
AUTOFILL Button – Pressing this button will
turn on the Auto Fill feature. The button
indicator is highlighted when the Auto Fill is
on.
PUMP Button – pressing this button will
turn the Water Pump on and off. The
button indicator is highlighted when the
pump is powered.
AUTOGEN Button – Pressing this button will
select the AGS screens. The button indicator
is highlighted when the Auto Charger is
enabled. (see AGS Screens below)
Block Heater Button – Pressing this button
toggles the Block Heater relay on/off. The
button indicator is highlighted yellow when
the load is being shed and blue when on.

STATUS DISPLAYS

Overall System Status - "OK" if no errors or
warnings are present.
Warnings and Errors will be displayed in this
area in order of priority.
Date/Outside Temperature/Time – The
system date, outside temperature and time
are displayed in this area.
Tank Status – The Fresh, and Holding tanks
status is displayed as a percentage of "Full".
Both a bar graph representation and a
numerical percentage are displayed.
DC Voltage – Both the House Battery
voltage and the Chassis Battery Voltage are
displayed. There is also a Lightning Bolt icon
that will illuminate when the isolator relay
(Charge Bridge) is energized and connecting
both battery systems together.
AC Power Source, Voltage and Current –The
AC Power Source
(Shore/Generator/Inverter), as well as, the
Voltage and Current (Amperage) for both
AC power legs are displayed.
Page 3