Mechanical Issues - Cornelius ABS 2.0 Service Manual

ABS 2.0 Service Manual
M I
ECHANICAL SSUES
Message
CLEAR CUP JAM
NO CUP EXTRACTED
TURRET STALLED
CONVEYOR STALLED
AIR OR CO LOW OR OUT
2
Publication Number: 621058590SER
Table 26
Explanation
Cup(s) is jammed in the conveyor at
the cup extraction position and the
conveyor and turret are unable to
operate.
Cup Tubes.
Loose or missing Hardware.
Cups.
The gripper did not or could not
extract a cup from the cup tube.
Grabber Pads.
CO
2
Cup Tubes.
Cups
Turret unable to rotate clockwise of
counter-clockwise.
Cup(s) is jammed in the conveyor at
the cup extraction position and the
conveyor and turret are unable to
operate.Does the conveyor rotate?
CO supply is low or empty or Air
2
compressor not operating
- 50 -
.
Remove all cups from the conveyor
cup holders at the Extract Position
before pressing the ENTER button.
Another cup will be extracted and
dispensing will continue.
Over stacking of cups in cup tubes.
DO not fill above the top of the cup
tube.
Cup tube fingers are damaged
(bent), replace all four fingers.
Cup tubes not properly mounted.
Remove and remount cup tubes.
Check each cup tube to insure all
hardware is present on the cup tube.
Replace any missing hardware.
Cups are packed together and will
not separate.
Check cup supply at the extract
station and make sure the cups are
not stuck. Make sure the gripper
pads are not damaged
Wet, dry off if damaged, replace.
Check bulk co
back up co
2
Cup tube fingers are damaged
(bent), replace all four fingers.
Cups are packed together and will
not separate.
Clear obstruction (cup holder, cup
tube or cup). Press ENTER
Remove all cups from the conveyor
cup holders at the EXTRACT
POSITION before pressing the
ENTER button. Another cup will be
extracted and dispensing will
continue.Make sure conveyor is
installed correctly. Repair or Replace.
Change CO
2
refilled.
Check cause not operating and
repair.
Correction
tank, if empty go to
2
and turn on.
cylinder or have bulk tank
© 2019, Cornelius Inc.