Run A Test Cook Cycle; Add/Edit Event Messages - TurboChef Eco Service Manual

Run a Test Cook Cycle

If desired, touch "Cook" to perform a test cook.
NOTE: The oven may require additional warm-up time before a test cook can be performed.
Figure 68: Run a Test Cook Cycle Screen

Add/Edit Event Messages

Event messages are alerts that pause a cook cycle and show a message. When cooking, the message will
appear immediately before the event to which the message was applied. For example, a message applied
to event 1 will appear before the cook cycle begins. Event messages must be specified at the time of
manufacture.
When event messages are specified, the Edit Item Screen is modified as shown in figure 69.
Touch the icon beneath the cook settings for the event you want to add a message to and, using the keypad,
input the name and touch "Enter." Once all changes are made, touch "SAVE."
Event 1 Event 2 Event 3 Event 4 Event 5
Time 70% 30% 0% 0% 0%
Air 80% 80% 10% 10% 10%
Microwave
10% 10% 10% 10% 10%
Instructions
CANCEL
Figure 69: Item Edit, Event Messages
NOTE: The field allows for a maximum of 32 characters.
NOTE: Touch the "123" icon to access numbers and symbols.
NOTE: Touch the icon to change case between upper and lower case.
NOTE: Touch the Alt icon to show special characters.
Event 6
0%
Name Item
10%
Time: 00:35
10%
COOK
SAVE
29