Huawei SUN2000-50KTL-JPM0 User Manual page 44

SUN2000-(50KTL-JPM0, 50KTL-JPM1, 63KTL-JPM0)
User Manual
Step 3 (Optional) To enhance the corrosion resistance of a ground terminal, apply silica gel or paint
around the terminal.
----End
Installing the AC Output Power Cable
Step 1 Remove the sealing nut and rubber liner from the AC OUTPUT cable gland.
Step 2 Route the cable through the cable gland.
1. Select appropriate rubber fittings based on the outer diameter of the AC power cable to
2. To avoid damaging the rubber fitting, do not route a cable with a crimped OT terminal
3. Adjusting a cable when the thread-lock sealing nut is tightened will shift the rubber fitting,
Figure 5-8 Routing a cable
Step 3 Remove an appropriate length of the jacket and insulation layer from the AC output power
cable using a wire stripper.
Ensure that the jacket is in the maintenance compartment.
Issue 01 (2018-09-30)
ensure proper sealing.
directly through the rubber fitting.
which will affect the Ingress Protection Rating of the device.
Copyright © Huawei Technologies Co., Ltd.
5 Electrical Connections
38