Restoring The Original Configuration - SOMFY Screen+Plug Original Instructions Manual

EN
Observations
The sensor is paired/set.
I have a wind
sensor and the
motorised product
rises to the upper
end limit every
The battery of the Somfy io wind
hour.
sensor is weak.
Despite the The sensor is not paired/set.
presence of a wind
sensor, when
it is windy, the
motorised product
does not reach the
upper position.
I don't think the The linear travel setting is incorrect.
position between
The motor is close to the thermal
the end limits is
limit.
accurate.

6.2. RESTORING THE ORIGINAL CONFIGURATION

Attention
Only switch off power (double cutout) for the motorised product to be reset.
This reset deletes all programmed control points, sensors, linear travel and resets the
motorised product's favourite (my) position.
1) Position the motorised product at its half-way position.
2) Cut the power supply for 2 seconds.
3) Switch the power supply back on for 5 to 15 seconds.
4) Cut the power supply for 2 seconds.
5) Switch the power supply back on.
The motorised product moves for a few seconds.
28
Possible causes
Copyright © 2017 SOMFY ACTIVITE SA, Société Anonyme.. All rights reserved.
Slim io Receiver Screen + Plug
Solutions
There is radio interference or the
sensor is out of reach. Position the
the Slim io Receiver Screen + Plug
outside the head rail.
Check whether the battery is weak
and replace it if necessary.
Refer to the corresponding guide to
pair/set the sensor.
Reset the linear travel.
Wait until the motor cools down.
OFF
ON
OFF
ON
2 s
5 s
15 s
2 s