Fitting The Underside Cover (Device-Dependent) - Fujitsu ESPRIMO Q55 Series Operating Manual

Getting started

Fitting the underside cover (device-dependent)

Rating type plate
FUJITSU Desktop ESPRIMO Q956/Q957:
At the time of device delivery, the bottom cover (2) is not yet mounted on the bottom
of the device, but packed along with the system so that you can read the type rating
plate (3) and the software licence information when preparing it for use.
The type rating plate and the software licence are affixed on the device cover and
is usually located below the mounted bottom cover so that it is not visible.
FUJITSU Desktop ESPRIMO Q55x/Q958:
With the FUJITSU Desktop ESPRIMO Q55x, the type rating plate is attached to the
underside of the device or to the right side of the device (when used vertically).
FUJITSU Desktop ESPRIMO Q956/Q957:
Only fit the underside cover if you are using the device in a horizontal or
vertical operating position without attaching it to a VESA interface (see
Section
If you are fitting the device onto the VESA interface of a monitor, you
must not fit the underside cover. If you do, the screw holes for the VESA
attachment will no longer be accessible.
1
Device with device cover (1), with bottom cover
mounted (2)
The device has a device cover (1) at the bottom. The device cover is divided into two:
during operation, the bottom cover (2) is inserted in the device cover.
In order to be able to mount the bottom cover prior to preparing it for use, proceed as follows:
18
"Setting up the device", Page
2
20).
1
Device with device cover (1) and visible type
plate (3, ESPRIMO Q956/Q967 only), no bottom
cover.
3
Fujitsu