Table of Contents
Advertisement
Setup
2.
Setup Procedure
Follow the steps below to set up.
STEP1
Installation procedure
Proceed accordingly with the instruction to set up the product correctly.
STEP2
Cable connection
STEP3
Turning on the power.
Reconfirm that you have correctly followed the steps 1and 2. Then, turn on the power.
If you find any errors or abnormalities after turning on the power, turn it off immediately
and check whether the setup has been properly conducted.
Installation
Before installing the stacking device, you need to unlock the fixed hooks of the product.
How to Unlock the Fixed Hooks
How to unlock the fixed hooks -1
(1)
Insert a slotted screwdriver (the point should be smaller than 4.5mm) into a hole (see the figure
below).
Figure 2.1. Unlock the fixed hooks-1 < 1 / 2 >
(2) By using the screwdriver as leverage, move it upward in the direction of the arrow to unlock.
ドライバー支点突起
Figure 2.1. Unlock the fixed hooks-1 < 2 / 2 >
CPS-AO-1604LI Hardware Manual
Projection tip
ドライバー支点用突起
Projection tip
差し込み用穴
Hole
2 Setup
7
Advertisement
Table of Contents
