Setup; Setup Procedure; Installation; How To Unlock The Fixed Hooks - Contec CPS-DO-16L Hardware Manual

Conprosys digital output module 16ch sink/source type

Table of Contents

Setup

Follow the steps below to set up.

STEP1

Installation procedure

Proceed accordingly with the instruction to set up the product correctly.

STEP2

Cable connection

STEP3

Turning on the power.

Reconfirm that you have correctly followed the steps 1and 2. Then, turn on the power.

If you find any errors or abnormalities after turning on the power, turn it off immediately

and check whether the setup has been properly conducted.

Before installing the stacking module, you need to unlock the fixed hooks of the product.

How to unlock the fixed hooks -1

(1) Insert a slotted screwdriver (the point should be smaller than 4.5mm) into a hole (see the figure

below).

Figure 2.1. Unlock the fixed hooks-1 < 1 / 2 >

(2) By using the screwdriver as leverage, move it upward in the direction of the arrow to unlock.

Projection tip

Figure 2.1. Unlock the fixed hooks-1 < 2 / 2 >

CPS-DO-16L, CPS-DO-16RL Hardware Manual

Projection tip

Hole

2 Setup

Table of Contents

Cps-do-16rl