Table of Contents
Advertisement
REASSEMBLY, REPAIR AND ADJUSTMENT
FUJICA AX -1
10 - 2 When the amplifier built in the camera is used.
a.
Use a shutter tester and adjust 1st and 2nd shutter blind traveling velocities
and shutter speed as indicated below.
o
Set the shutter speed selector dial to 1/60 sec.
o
Adjust 1st and 2nd shutter blind traveling velocities to 12.0 msec. and
12.8 msec. respectively.
o
Set the shutter speed selector dial to "AE", and move the aperture
transmission ring properly so that the LED between 1000 and 500
flashes in the viewfinder.
o
With the shutter release button depressed in a half way (AEL mode),
select a proper interval capacitor sot that the shutter tester counts
about 0.8 msec (1 msec to 0.6 msec.).
b. Checking exposure value
o
With an exposure tester, measure exposure levels at LV11 and LV7.
o
Select a proper interval capacitor so that exposure levels at LV14 and
LV15 are in parallel to the exposure levels measured as above.
When correcting center value (level), adjust level of the amplifier.
- 7 8 -
Hide quick links:
Advertisement
Table of Contents
