Lock Pin; Installing Mirror Assembly; Lens Mount Base Assembly (3 - 54) - FujiFilm Fujica AX-1 Repair Manual And Part List

REASSEMBLY, REPAIR AND ADJUSTMENT
FUJICA AX -1
6.

Lens mount base assembly (3 - 54)

6 -1

Lock pin (3 - 42)

a. Make sure that the lock pin moves smoothly and that it can be pushed
down below the flange surface correctly.
b. Make sure that the lock pin is projected correctly by the leaf spring (3-27).
6 - 2 Button (3-49)
a. Insert the projection of the lever (3 - 48) into the guide groove on the
diecast lens mount base, and combine the button (3 - 49) with the lever
(3 - 48) in such a manner as that the button and lever hold the diecast lens
mount base between them.
b. Push the button into the lens mount base until it conies into contact with
the lever.
c. Install the lever and button with Araldite.
6 - 3

Installing mirror assembly (4 -1)

o Tighten four screws (3 - 51) at the front face of the lens mount bast-, tighten
two screws (3 - 55) at the side, and thus, install the mirror assembly on
the lens mount base.
- 6 0 -