Table of Contents
Advertisement
REASSEMBLY, REPAIR AND ADJUSTMENT
FUJICA AX -1
1 -14 Installing gear (6-54) and lever (6-20)
a.
Check the lever (6 - 20) to insure that it is positioned against the gear
(6-21) as shown in the right hand figure.
b.
Hook the spring (6-17) on the position shown in the right hand figure.
c.
Check the gear (6-21) to insure that it engages with the gear (6 - 8)
when the bent portion of the lever (6-20) is pushed by the film
chamber door.
d.
Installing gear (6 - 54)
o
With the shutter charged (with the film advance lever wound up
completely), set the gear (6 - 21) in the position shown in the right
hand figure.
o Install the gear (6 - 54) on the sprocket shaft (6 - 82).
NOTE:
e.
The gear (6-21) turns 360° per frame.
The engaging groove (engagement between the sprocket gear
and sprocket shaft) is equally divided into three sections.
For this reason, if the gear (6 - 21) is not positioned as shown
in the right hand figure, the feeding notch of the gear (6-21)
engages with the gear (6 - 8), causing the dial plate to indicate
wrong exposure number.
- 3 4 -
Hide quick links:
Advertisement
Table of Contents
