Image And Trace; Dust Specks Appear In Photographed Images; Sync. Terminal Dislodged; The Camera Does Not Automatically Switch To Vertical Position When Auto Rotate Function Is Set To On - FujiFilm FinePix S3Pro Troubleshooting Manual

FinePix S3Pro TROUBLESHOOTING GUIDE

3. Image and trace

3-1. Dust specks appear in photographed images

Fault details: Dust specks appear in photographed images.
Analysis results: Dust on the LPF.
Repair details:
Cleaned the LPF

3-2. Sync. terminal dislodged

Fault details: When the sync. terminal cap was removed, the terminal itself broke off.
Analysis results: Presumed to be caused by looseness due to incomplete fastening and adhesion when the
sync. terminal was attached.
Repair details:
Replace the Sync. terminal
3-3. The camera does not automatically switch to vertical position when auto rotate function
is set to ON
Fault details: The camera does not automatically switch to vertical position when auto rotate function is
set to ON.
Analysis results: Defect in MAIN PWB ASSY IC120 (vertical position detection sensor).
Repair details:
See Bulletin GS-2005-025
3-4. The camera does not automatically switch to vertical position when auto rotate
function is set to ON
Fault details: The camera does not automatically switch to vertical position when auto rotate function
is set to ON.
Analysis results: Defect in the vertical position detection sensor mounted on a modified board.
Repair details:
Replaced the vertical position detection sensor (IC120).
7