Assembling Focal Plane Shutter Assembly - FujiFilm Fujica AX-1 Repair Manual And Part List

REASSEMBLY, REPAIR AND ADJUSTMENT
FUJICA A X - 1
4.

Assembling focal plane shutter assembly (5 - 20)

a. Combine the battery compartment (5 - 62), contact piece (5 • 60), contact point
(5-63) and spring (5-64), and install them on the base plate (5-66) with two
screws (5-65).
b. Install the column (5-29) on the base plate (5 -66) with the screw (5-78).
c. Combine the 2nd shutter blind assembly (5 - 30) and 1st shutter blind assembly
(5 - 46) with two large rollers (5 - 58), two small rollers (5 - 59) and washer
(5-57) as shown in the right hand figure, and fit them on the shaft holder on
the base plate (5-66).
d. Match the base plate (5 - 25) to the shutter blind spindles, and install the base
plate with two screws (5 - 23) and screw (5 - 22).
e. Install two E- clips (5-76) and two E- clips (5-21) on the shutter blind
spindles.
f. Install the light shielding plate (5-27) with two screws (5-26).
NOTE: Be careful not to allow the light shielding plate (5 - 27) coming into
contact with the metal fixture (5 - 32).
If it drags, shutter blind velocity will fluctuate.
g. Install the moquette (5 - 28) with Pliobond.
- 4 2 -