The Lavit Cold Beverage Dispenser; The Lavit Cold Beverage Capsule; Cold Mix Chamber; Cold Tanks - Lavit LB115 Service Manual

The Lavit Cold Beverage Dispenser

The Lavit Beverage Dispenser is designed to dispense either cold still water, cold sparkling water,
or a Lavit beverage, which can be made with either still water or sparkling water, depending on
the beverage type. When selecting a Lavit beverage using sparkling water, the beverage can be
crafted using a choice of carbonation levels: soft, medium, or full.

The Lavit Cold Beverage Capsule

Cold Mix Chamber

The primary function of the Lavit Beverage Dispenser is to make cold, flavored, and healthy
drinks. The mix chamber is designed to receive a Lavit beverage capsule, crack and peel the top
lidding, introduce a mix stream, and process and merge the beverage stream with a still or
sparkling water finishing stream. The key components of the mix chamber include the blue
capsule tray where a capsule is placed, the silicone water nozzle for the mix and finishing streams,
and the entire capsule carriage which tilts forward to dispense the mixed beverage into the
finishing stream. The carriage begins and ends it cycling at the HOME POSITION.

Cold Tanks

The cold still water tank has a storage capacity of 1.3 gallon (5 liter) of cold water and is made
from 304 stainless steel. Sparkling water is made in a secondary 0.26-gallon (1 liter) capacity
tank made from 304 stainless steel. The sparkling water tank sits inside the cold still water tank
in a unique tank in tank system. The whole assembly is made cold by a fully immersed direct chill
evaporator. The cold-water temperature is microprocessor controlled, is non- - - adjustable, and is
factory set at 37.4F (3C)
Filter and CO Cylinder Side Compartment
2
The door on the right side of the dispenser provides access to the filter and CO
compartment. The recommended Lavit ECO3 filter or a Lavit Bottled Water pump is mounted
towards the front of the compartment. Connection points for both are molded in the compartment
side wall. The CO pressure regulator and gas cylinder are mounted towards the rear of the
2
compartment.
The Lavit beverage capsule and top lidding are made from aluminum and
are fully recyclable without any additional processing. Each capsule is
designed to be a single use mixing chamber for the beverage selection. This
approach eliminates all possible beverage cross contamination.
5
cylinder
2