Lavit LB115 Service Manual page 21

12. The dispenser will self-- - check on every power up and if OK will go to the LCD home screen
and the Lavit Button halo will be red.
13. TO FILL THE DISPENSER WITH WATER, TURN THE LAVIT PUMP TO ON, PUSH THE
LAVIT BUTTON AND THE DISPENSER WILL START TO FILL. The screen will display a
WATER TANK FILLING SCREEN.
14. When the water tanks are half filled, the compressor will turn on and start to chill. The soda
pump will also turn on when the water tank is half full. The HOME screen will appear.
15. When the HOME screen appears turn the CO
3.5 BAR OF PRESSURE BY ROTATING THE KNOB CLOCKWISE. 3.5 BAR OF PRESSURE
(50 PSI) IS INDICATED AT THE BEGINNING OF THE RED SCALE ON THE REGULATOR.
The soda tank will fill with CO
16. Purge any air from the system by toggling the CO
unit. Purge gas about 3 times for 2 seconds each time.
17. If the water tanks do not fill within 5 minutes the water inlet valve will automatically close.
This feature is a safety feature that prevents the continuous running of water in the case of
a water leak. An error screen indicating a possible leak will be displayed. To clear the
dispenser of this condition, turn the power off and then back on. Reset the Lavit Pump if
necessary (Red Light) by pushing the reset button on the pump. The reset should be green.
18. Push the Lavit Button again and the tanks will then automatically continue filling to
capacity and shut off and the Lavit button halo will be blue.
19. While the water tanks are filling and the compressor is chilling the water, set the current
date and time by pressing the gear shaped Service Icon on the lower left of the HOME
gas pressure on. SET THE REGULATORTO
2
gas.
2
Purge Valve located in the rear of the
2
20
TM170915-B