Table of Contents
Advertisement
9. IN ANY KNOWN AREA WITH HIGH SEDIMENT WATER, A PRE- - - S EDIMENT FILTER
SHOULD BE INSTALLED BEFORE THE DISPENSER.
10. Ensure that the Power Switch is in the OFF position (bottom in). Connect the power cord.
11. Locate the CO
inlet pressure line inside the side compartment. Extend the line away from
2
the dispenser and trim the line using a tubing cutter so that the final length of the tube
extends to the inside of the door hinge.
12. Connect the supplied CO
fully off by turning the knob fully counterclockwise.
13. Wipe the bottle threads and screw the supplied 1.5-pound CO
regulator. DO NOT TURN THE GAS PRESSURE ON AT THIS
in the side compartment ensuring the
Lavit Document: TM170915---A
pressure regulator to the inlet tubing. Ensure that the regulator is
2
side door properly closes.
15
cylinder onto the
2
POINT. Place the cylinder
TM170915-B
Hide quick links:
Advertisement
Table of Contents
