Rear Panel; Microprocessor Control And Touchscreen - Lavit LB115 Service Manual

Rear Panel

The rear panel on the Lavit Dispenser has the following features:
CO2 Purge – the toggle on the upper left (from the front of the unit) allows CO2 gas to be
purged from the system. Purging is required on the initial set up and at any time gas
pressure is to be released from the unit.
Power Socket – the supplied power cord attaches into the power socket on the lower right.
Power Switch – the power switch is used to power on or power off the unit.
Water Inlet – a quick connect ¼" fitting for the inlet water line. When initially installing
the water, line push the line in a second time when water pressure is applied to ensure
a complete seal.
Water Drain – the drain on the lower left of the panel is used to drain down the 5-liter
cold water tank. The drain plug is secured with a screw. To remove the drain plug rotate it
90 degrees to the left.

Microprocessor Control and Touchscreen

The Lavit Dispenser is a microprocessor-controlled beverage and water dispenser with a LCD
touch screen providing the user an operating interface and to display process information. The
microprocessor controls temperature, water filling, water levels, capsule mixing, water finishing
streams, operating of the mix chamber, and dispenser status. The touchscreen will default to the
HOME SCREEN when the unit is ready to dispense water or a beverage.
ANY SCREEN (OTHER THAN THE HOME SCREEN) CAN BE EXITED AT ANY TIME BY PRESSING
THE BACK ARROW ON THE UPPER LEFT OF THE DISPLAYED SCREEN.
6