Lavit LB115 Service Manual page 22

screen.
20. From the Date/Time Screen, enter the Service Menu by pressing the Service Setup icon.
21. From the Service Menu select and make the following choices:
Enter MAX TEMP and DISABLE (when disabled the icon will read "Enable").
Set the Filter Timer to DISABLE (when Disabled the icon will read "Enable"). Filter life is
not tracked for Bottled Water installations.
Enable or Disable Sleep Mode.
Select WATER SETUP and display the water calibration screen. Calibrate the three
water streams (mix, still and sparkling) by following the Water Calibration
Procedure found at the end of this Section 2, Page 25.
22. After completing the water calibration return to the HOME screen by pressing the Return
Arrow in the upper left of the touchscreen to back out of all service screens.
23. Check for CO leaks, check for water leaks.
2
24. The dispenser should now be ready to use after the dispenser reaches temperature. The
first cooling cycle will take approximately 70 minutes.
25. Enable and set the MAX TEMP if so desired to ensure that every beverage is served chilled.
It is recommended that this feature is Disabled unless a user has asked for colder
beverages.
26. Should the 5-gallon bottle run out of water then the Lavit pump kit will sound an alarm
and the reset button will turn from green to red. Change the bottle and press the reset
button. Failure to change the bottle could result in a dry vend on a capsulebeverage.
21
TM170915-B