Lavit LB115 Service Manual page 19

2. Cut the water pipe loop and place the two ends of the pipe into the Lavit Bottled Water
Pump marked in and out. The right-hand side of the loop is water in.
3. Fit the pump into the side compartment using the slots in the bottom of the panel and the
screw attachment points. Plug the pump into the supplied power socket inside the
compartment. Ensure the Pump Power Switch is OFF.
4. Place the 5-gallon bottle within six (6) feet of the machine and remove the bottle seal.
5. Fit the water bayonet into the bottle and seal the bottle with the cap located on the water
bayonet.
6. Connect the ¼" water tubing from the top of the water bayonet to the water inlet
connection at rear of the dispenser.
7. Ensure that the Dispenser Power Switch is in the OFF position (bottom in). Connect the
power cord.
8. Locate the CO inlet pressure line inside the side compartment. Extend the line away from
2
the dispenser and trim the line using a tubing cutter so that the final length of the tube
extends to or slightly past the inside of the door hinge.
18
TM170915-B