Decommissioning The Lavit Dispenser - Lavit LB115 Service Manual

Section 8: Decommissioning the Lavit Dispenser
Before transporting the Lavit dispenser, it must be drained of all water and the CO2 bottle
removed.
1. Turn off the water supply to the machine. Dispense a small amount of still water to relieve
the pressure in the inlet line. Disconnect the water inlet line.
2. Remove the drip tray. Set aside for repacking.
3. Power OFF the dispenser. Disconnect the Power Cord.
4. Turn the dispenser to gain access to the rear Cold-Water Tank drain plug.
5. Remove the drain plug and empty the cold-water tank into a suitably sized bucket.
6. Replace the drain plug.
7. Turn dispenser and connect the power cord and turn the Power ON.
8. Enter the SERVICE MENU and select WATER SETUP.
9. Place the empty bucket under the water dispense point.
10. Locate the EMPTY SODA icon on the screen. Press the icon until all soda water is dispensed
into the bucket. The dispenser will discharge CO2 gas when the soda tank is empty.
11. Turn Power OFF. Disconnect power cord and wrap for repacking.
12. Turn the CO2 regulator to the off position and remove the CO2 bottle. Remove or secure the
CO2 regulator for transport.
13. Actuate the CO2 purge valve on the rear of the dispenser until CO2 flow ceases.
14. Repackage the dispenser, drip tray, power cord, and regulator for transportation.
45
TM170915-B