Table of Contents
Advertisement
Section 2: Installation
Installation Overview
The Lavit Beverage Dispenser is designed to be installed in one of three ways.
Option 1: A POU connection to a mains water supply, fitted with a Lavit ECO3 filter.
Option 2: A 5-gallon bottled water supply using a Lavit pump kit.
Option 3: Connected to an AquaHost water dispenser with an AquaHost pump kit.
Instructions for installing a Lavit dispenser for each option are provided below.
Pre-Delivery Inspection
Prior to installing the Lavit Dispenser in one of three installation options, please conduct an
inspection of the unit.
1. Unpack the unit. Verify that the power cord, drip tray, and CO
included in the side walls of the foam packaging. Remove and set aside.
2. Remove the plastic bag from the unit and inspect the unit for any shipping damage. Open
and close the mix chamber to ensure proper operation. Open and close the side panel
access door to ensure proper functioning.
3. Verify that the blue capsule tray in the mix chamber is properly attached and free to move.
4. Ensure that the silicone nozzle is the mix chamber is tightly fastened and properly aligned
straight up and down.
5. Note any damage and report any damage to your service supervisor.
6. It is recommended that all packaging material is saved and returned to your service
location to be used when transporting or storing a dispenser in the future.
Lavit Document: TM170915---A
pressure regulator are
2
10
TM170915-B
Hide quick links:
Advertisement
Table of Contents
