Table of Contents
Advertisement
16. Align holes in the switch housing with holes in the
fitter plate. Reinstall the three screws and washers
that were previously removed. Use a Phillips
screwdriver (not included) to secure all screws.
(Fig. 16).
Screw
17. Install bulbs (Fig. 17).
Important: When replacing the bulb, allow bulb and
light kit to cool before touching.
18. Remove the pre-installed rubber washer, nut, end
cap, and finial from the light kit (Fig. 18).
LIGHT KIT INSTALLATION
11
Fig. 16
Screw and
Washer
Fig. 17
Bulb
Fig. 18
Nut
Rubber
Washer
End Cap
Finial
Advertisement
Table of Contents
