Motor Housing Installation - Honeywell EASTOVER 10214 Owner's Manual

9. Remove the ten motor screws from the underside of
the motor. Set aside for blade arm assembly (Fig. 9).
Note: A cutout in the fitter plate allows easy access
to the motor screw holes.
Motor Screw
10. Temporarily lift the motor housing to the mounting
bracket to determine which two motor housing
screws in the sides of the mounting bracket align
with the slotted holes in the top edge of the motor
housing. Partially loosen the two motor housing
mounting screws that align with the slotted holes.
Remove the other two motor housing mounting
screws from opposite sides of the mounting bracket
(Fig. 10).
Motor Housing
Screw
11. Slide the motor housing over the motor, aligning
the slotted holes in the motor housing with the two
loosened motor housing mounting screws in the
mounting bracket. Twist motor housing to lock. Then
reinstall the two previously-removed motor housing
mounting screws and securely tighten all screws
(Fig. 11).
Motor Housing
Screw

MOTOR HOUSING INSTALLATION

Fig. 9
Fig. 10
Mounting
Bracket
Fig. 11
8
Cut Out
Motor Screw
Motor
Housing
Screws
Motor
Housing
Motor
Housing
Screws