Sony Trinitron PVM-20M4A Operating Instructions Manual page 7

Note
The PHASE (6), CHROMA (7) and APERTURE
(9) controls have no effect on the pictures of RGB
signals.
0 MENU (EXIT) button
Press this button to display the main menu.
When a menu is on the display, you can return to the
previous menu by pressing this button.
!¡ ENTER (SELECT) button
Press the button to confirm a selected item on the
menu.
!™ > (+)/ . (–) buttons
Press the buttons to move the cursor (z) or adjust
selected item on the menu.
!£ 16:9 selector
Press this selector (light on) to monitor the signals of
16:9 picture.
!¢ H/V DELAY selector
Press this selector (light on) to observe the horizontal
and vertical sync signals at the same time.
The horizontal sync signal is displayed in the left
quarter of the screen; the vertical sync signal is
displayed near the center of the screen.
!∞ UNDER SCAN selector
Press this selector (light on) for underscanning.
The display size is reduced by approximately 5% so
that four corners of the raster are visible.
!§ BLUE ONLY selector
RESET button
• As the BLUE ONLY selector, press this selector
(light on) to eliminate the red and green signals.
Only blue signal is displayed as an apparent
monochrome picture on the screen. This facilitates
"chroma" and "phase" adjustments and observation
of VCR noise.
("Phase" adjustment is effective only for the NTSC
signals.)
• As the RESET button, you can reset the menu
settings by pressing this button when a menu is on
the display.
!¶ DEGAUSS button
Press this button momentarily. The screen will be
demagnetized. Wait for 10 minutes or more before
using this button again.
!• EXT SYNC (external sync) selector
• Set this selector to the off position (light off) to
operate the monitor on the sync signal from the
displayed video signal.
• Set this selector to the on position (light on) to
operate the monitor on an external sync signal
through the EXT SYNC connector.
!ª LINE/RGB input selector
Press this selector to select the input to be monitored.
• Set this selector to the off position (light off) to
monitor the signal through the LINE A, LINE B or
LINE C connectors.
• Set this selector to the on position (light on) to
monitor the signal through the RGB/COMPONENT
connectors.
@º C/SDI selector
• When the LINE/RGB input selector is set to the
LINE position (light off), press this selector (light
on) to monitor the signal through the LINE C
connectors.
• When the LINE/RGB input selector is set to the
RGB position (light on), press this selector (light on)
to monitor the SDI signal (optional kits are required).
@¡ B/COMPONENT selector
• When the LINE/RGB input selector is set to the
LINE position (light off), press this selector (light
on) to monitor the signal through the LINE B
connectors.
• When the LINE/RGB input selector is set to the
RGB position (light on), press this selector (light on)
to monitor the component signal through the RGB/
COMPONENT connectors.
@™ A/RGB selector
• When the LINE/RGB input selector is set to the
LINE position (light off), press this selector (light
on) to monitor the signal through the LINE A
connectors.
• When the LINE/RGB input selector is set to the
RGB position (light on), press this selector (light on)
to monitor the RGB signal through the RGB/
COMPONENT connectors.
7